Incorrect x/y coordinate calculation for some NPC Entities

NPC: "crossovers.bunny"

Calculated sheets.fix[0].x position should be 0 but is 32.

[Vegita2]

in what map is the npc used?

I can't find the map with bunny in it, but it also breaks for "crossovers.turing"
map: "rookie-harbor.test"

These rely on animSheet.SUB entries

[Vegita2]

Maybe because of this line?

crosscode-map-editor/webapp/src/app/shared/phaser/entities/registry/npc.ts

Line 175 in 673bfbb

x = sheet.offX || x;

if sheet.offX is 0 it is not used because it evaluates to falsy

Possibly. I need to check

[Vegita2]

Maybe because of this line?

crosscode-map-editor/webapp/src/app/shared/phaser/entities/registry/npc.ts

Line 175 in 673bfbb

x = sheet.offX || x;

if sheet.offX is 0 it is not used because it evaluates to falsy

It's not because of this. The hardcoded NPCSimple is used to offset the frames, but the npc crossovers.turing only has one frame so the offset is wrong.
I don't really know how to fix it, or in general how the npc's get their sprites

[XenonA7]

I have noticed this too, it seems to be quite widespread. NPCs rendered in the map editor are always slightly off from their positions in-game. Here is an example comparing the map editor (first image) versus in-game (second image), note the position of the character's feet compared to the floor pattern:

It's not always the same offset however. Here is another example. First image is map editor, second image is in-game:

The first example was higher in-game and the second example was lower in-game. It seems to be different for different NPCs, their "config" setting in the NpcState, and perhaps their "face" setting.

This is a minor annoyance that makes it impossible to be pixel-perfect while placing NPCs. I also like to position NPCs around in the editor temporarily to note coordinates for navigation waypoints, and this means those will always be slightly off.