Building Kong on s390x

Building Kong on s390x

The instructions provided below specify the steps to build Kong version 2.1.4 or Kong 'next' on Linux on IBM Z for the following distributions:

• Ubuntu (18.04)

If you do not need a custom build of Kong on s390x, you may opt for the multi-arch alpine docker image docker.io/linuxforhealth/kong:2.1.4 which supports amd64, arm64 and s390x.

Note: When following the steps below you will need access to the docker command and may therefore need to sudo su.

Step 1: Build Kong.

1.1) Set up your build repos Clone the LinuxForHealth kong, kong-build-tools and docker-kong repositories:

git clone https://github.com/LinuxForHealth/kong.git
git clone https://github.com/LinuxForHealth/kong-build-tools.git
git clone https://github.com/LinuxForHealth/docker-kong.git

The kong-build-tools and docker-kong repos contain the s390x build modifications. The kong repo contains no modifications, but is at the current tested level of the Kong next branch for s390x builds. Clone the repos into the same directory, so kong, kong-build-tools and docker-kong are at the same directory level.

1.2) Choose your Kong branch
If you are building against Kong 2.1.4, check out the 2.1.4 tagged release:

cd kong
git checkout tags/2.1.4

If you are building against the Kong next branch, check out the next branch:

cd kong
git checkout next

1.2) Set the OpenResty version Navigate to Dockerfile.openresty and set the

1.3) Set your docker repo

1.4) Build Kong apk

1.5) Build Kong alpine image

Step 2: Test Kong (Optional)

2.1) Run all test cases

References: