Home Accessory Architect v0.0.6

IMPORTANT: JSON has a new format. Old JSON strings will not work.

• Added customizable button filter.
• Added declarations of buttons array to enter in setup mode.
• Now every Homekit accessory state has a configurable action.
• Removed "inverted" from digital outputs (relays).
• Added "inching mode" to Homekit accessories.
• Added "inching mode" to individual digital output actions.

Read Wiki for more info.

Home Accessory Architect v0.0.5

• Added Stateless button accessory type.

Read Wiki for more info.

Home Accessory Architect v0.0.4

• Fixed possible bug entering in Setup Mode.

Read Wiki for more info.

Home Accessory Architect v0.0.3

• Fixes critical bug in prior version about new installations.
• Internal pull-up resistor now is enabled by default in buttons.
• OTA update option only appears when LCM firmware is installed.
• Now inverted status pin is applied in relays/outputs at boot.
• Many improvements.

Read Wiki for more info.

Home Accessory Architect v0.0.2

This version has a critical bug and must not be used with new installations. It only works when updating from v0.0.1

• Added accessory type 2 (outlets).
• Added OTA updates support from Setup mode.
• Added a way to reset HomeKit accessory ID from Setup mode.
• Some general improvements.

Read Wiki for more info.

Home Accessory Architect v0.0.1

• Very first release.
• Only accessory type 1 is supported.
• OTA updates are not supported yet.
• There is no way to reset HomeKit accessory ID (Only erasing flash).

Read Wiki for more info.