Teensy Compatibility

Teensy Compatibility

While there are differences between the various ARM Teensys there is also a lot of commonality. This can allow you to lay out a basic breadboard or prototype board, and move between different Teensys.

The areas where ARM Teensys are compatible are:

• The first 28 pins are laid out in a 2x14 grid, with the Teensy being 0.7" wide;
• The main ground, VIN, and 3.3v pins are in the same location;
• The analog ground pin in the Teensy 3.1, 3.2, 3.5, and 3.6 is in the same location as the secondary ground pin in the Teensy LC and 4.0. Thus you should use this ground pin for the analog pins;
• The inner pin VUSB that gives the USB voltage is in the same spot in all Teensys;
• All Teensys have a solder joint that normally connects VIN and VUSB to power the Teensy, but you can cut the solder connection if you want to separate the USB from the normal power pin;
• Pins 0/1 are connected to the first serial port;
• Pins 7/8 are also connected to a serial port, though it is Serial2 in the Teensy 4.0 and Serial3 in the Teensy 3.x and LC boards;
• Pins 11/12/13 are the first SPI port (MOSI, MISO, and SCLK). Pin 10 is commonly used for the CS pin;
• Pin 13 is connected to a LED to allow simple blinking scripts;
• The USB connection is known as just Serial.
• Pins 18/19 are the first I2C port. Note, that on all Teensys you must have hardware pullup resistors between each of the pins and 3.3v;
• Analog inputs can be done on pins 14-23. These pins have the alternate names of A0..A9;
• Pins 3, 4, 6, 22, and 23 are the common PWM (pulse-width modulation) pins across all Teensys.