-
Notifications
You must be signed in to change notification settings - Fork 5
Teensy Shields and Breakout Boards
MichaelMeissner edited this page Mar 18, 2020
·
24 revisions
- Teensy prop shield with motion sensor
- Teensy low cost prop shield, no motion sensor
- Teensy audio adapter
- Adafruit Teensy -> Feather Adapter
- Sparkfun Teensy -> Arduino shield
- STBC08 High-Current LiPo Battery Charger
- LiPo battery charger add-on
- Nano-sized LiPo Charger for Teensy
- Burgess World: Arduino shield for Teensy 4.0, ESP8266 wifi, bluetooth
- Burgess World: Arduino shield for Teensy 3.2, ESP8266 wifi, bluetooth
- HighCee Aerial Robotics: JST GH-1.25-4P connectors for I2C0, I2C1, CAN0, CAN1, SER2 and SER5
- Break out Teensy 3.2/4.0 to use screw terminals
- Phin6 MIDI Controller (powered by Teensy)
- Teensy 3/LC Proto board, Arduino Shield, nRF24L01+
- Arduino Teensy Guitar Audio Shield
- Adapt Teensy 4.0 to Teensy Guitar Audio Shield
- Teensy 3.2 CAN bus module
- Teensy 3.5 Motor Control
- TeeNaps :: EEG Hat (For Teensy 3.2)
- Dual CAN-Bus adapter for Teensy 3.5, 3.6
- Teensy Adapter for RetroShield
- Lightsaber Prop Shield for Teensy 3.2
- Teensy Beats Shield Bare PCB
- Loglows Teensy Tindie page
- OSH park PCB to access Teensy 3.2 bottom pads from FrankB
- OSH park PCB to access Teensy 3.5/3.6 bottom pads from W7PUA
- pcbs.io PCB to convert Teensy 3.5/3.6 pinout to Teensy 3.2 from FrankB
- PJRC has this list: breakout-board-for-teensy-4-0
- Hyperbolic Labs tindie.com store for Teensy 4.0 Ultimate Breakout Board -- sold out since October 2019
- Loglow thread for his forthcoming Teensy 4.0 shield
Teensy is a PJRC trademark. Notes here are for reference and will typically refer to the ARM variants unless noted.