Error displayed when setting Fan Mode using "Expert commands"

[Fingerz]

When trying to use the Expert UI to set Fan Mode on a thermostat using the "Expert commands" tab of the Configuration section, I get the following error message:

When I check the log file, this is what I'm seeing:

[2017-01-12 09:08:56.380] [D] [zway] SETDATA controller.data.incomingPacket.nodeId = 185 (0x000000b9)
[2017-01-12 09:08:56.380] [D] [zway] SETDATA controller.data.incomingPacket.frameType = "singlecast"
[2017-01-12 09:08:56.380] [D] [zway] SETDATA controller.data.incomingPacket = **********
[2017-01-12 09:08:56.380] [D] [zway] SETDATA devices.185.data.lastReceived = 0 (0x00000000)
[2017-01-12 09:08:56.381] [D] [zway] SETDATA devices.185.instances.0.commandClasses.136.data.bytes = byte[4]
[2017-01-12 09:08:56.381] [D] [zway]   ( 02 03 01 00 )
[2017-01-12 09:08:58.952] [D] [zway] RECEIVED: ( 01 0C 00 04 00 86 06 31 05 01 42 08 48 40 )
[2017-01-12 09:08:58.956] [D] [zway] SENT ACK

A more detailed log file is attached.
z-way-server-thermostat-bug.log.txt

[PoltoS]

Strange, but the error corresponding to the one on the screenshot is not in your log.

But the problem is that it should have two params, not one.

You can try to execute this: http://ip:8083/JS/Run/zway.devices[185].commandClasses[68].Set(1,1)

Please also try v2.3.0-rc6 - it should have some fixes of Expert UI. May be it was already fixed there.

[Fingerz]

The command executed perfectly. I will try and make time this week to install the release candidate and see if the Expert UI issue I've seen has been fixed.