TRUE nass Core Installation in a PROXMOX VM

In This Page i will show you how to install TrueNas Core in a Proxmox VM

1. Go to the official website of the truenass and download truenass core package ISO file.
2. Upload the ISO file in Proxmox
3. Create a VM In Proxmox Using a TrueNass Core ISO file with 8gb ram, 2 processor cores and SCSI storage type but do not start it yet.
4. login to your Proxmox server via .SSH.
5. Type the following command.

lsblk -o +MODEL,SERIAL 

it will list all the drives with their model and serial number and hard drives will be listed as sda and sdb

ls /dev/disk/by-id

it will show you the hard drives connected to your motherboard.

• sata drives are listed as follows: ata 0r if it is not listed as ata it will be listed with scsi

6. Add the sata drives by running following command

qm set 103 -scsi2 /dev/disk/by-id/ata-ST3250318AS_9VY9660G

• 103 is a id of vm
• scsi2 is the storage type
• ata-ST3250318AS_9VY9660G is the hard drive model and serial number

7. Add all the drives using the same command but with minor changes like previous hard was added using scsci 2 the next drive will be added with scsi 3 and its serial and model & so on.
8. Start the VM and install TrueNass Core