-
Notifications
You must be signed in to change notification settings - Fork 16
Developer's Guide
Curtis Malainey edited this page Apr 7, 2017
·
8 revisions
Welcome to the ant-arduino wiki!
Recommended Wiring (Use at your own risk!) Use a level shifter if using a 5V arduino.
- 1 (VCC) -> 3.3V Rail
- 2 (GND) -> GND
- 3 (RXD) -> (TX)
- 4 (TXD) -> (RX)
- 5 (RTS) -> (CTS) (Serial Flow Control Pin) (if available)
- 6 (RST) -> GPIO its the reset pin, (grounding will reset the radio, personally I prefer using the ResetMessage)
- 10 (SLEEP) -> GND (will go to a GPIO later once library supports sleeping, just a power consumption tool)
- 17 (PORTSEL) -> GND (Sets to Async rather than SPI)
- 18 (BR1) -> 3.3V Rail (controls BAUD rate) (this configuration will give you a 9600 BAUD Async connection to the radio)
- 19 (BR2) -> GND (controls BAUD rate)
- 20 (BR3) -> 3.3V Rail (controls BAUD rate)