Developer's Guide

Welcome to the ant-arduino wiki!

Recommended Wiring (Use at your own risk!) Use a level shifter if using a 5V arduino. 1 (VCC) -> 3.3V Rail 2 (GND) -> GND 3 (RXD) -> (TX) 4 (TXD) -> (RX) 5 (RTS) -> (CTS) (Serial Flow Control Pin) (if available) 6 (RST) -> GPIO its the reset pin, (grounding will reset the radio, personally I prefer using the ResetMessage) 10 (SLEEP) -> GND (will go to a GPIO later once library supports sleeping, just a power consumption tool) 17 (PORTSEL) -> GND (Sets to Async rather than SPI) 18 (BR1) -> 3.3V Rail (controls BAUD rate) (this configuration will give you a 9600 BAUD Async connection to the radio) 19 (BR2) -> GND (controls BAUD rate) 20 (BR3) -> 3.3V Rail (controls BAUD rate)