🐛 DXF will not nest unless some parts deleted. #154
Description
I have a dxf that will not nest until I delete [or set to 0] 5 parts that are larger than the remaining 54 parts.
The parts that will nest range from 20.0x29.0 down to 1.0x0.9. They fit nicely into a 48x96 sheet. It will even put a couple of the small parts into a drop of a larger part.
The deleted parts are 72.0x30.0 (2x), 62.0x24.9 (2x), & 55.6x26.8. I have even let run overnight and all I get is a full progress bar and blank output. These parts will nest using 2 sheets with a lot of lost material so they are not the issue.
I cannot upload the document as that it is proprietary information. [That is to the general public until the property opens]. Is there some place I send that isn’t public?
I could use some help as that the material is around $250 a sheet
Notes:
All dimensions in inches.
Running on Windows 10, 13th Gen Intel (r) Core (tm) i9-13900. Side note – According to Task Manager, when it starts nesting all 24 cores are running at 100%. After a couple seconds, it drops to 2 cores. No matter the core count in settings.