Lidl auriol docs

components/remote_receiver.rst

@@ -65,6 +65,7 @@ Configuration variables:
   - **toshiba_ac**: Decode and dump Toshiba AC infrared codes.
   - **mirage**: Decode and dump Mirage infrared codes.
   - **toto**: Decode and dump Toto infrared codes.
+  - **lidl_auriol**: Decode and dump Lidl Weather Station data.
 
 - **tolerance** (*Optional*, int, :ref:`config-time` or mapping): The percentage or time that the remote signal lengths
   can deviate in the decoding process.  Defaults to ``25%``.
@@ -232,6 +233,9 @@ Automations:
 - **on_toto** (*Optional*, :ref:`Automation <automation>`): An automation to perform when a
   Toto remote code has been decoded. A variable ``x`` of type :apistruct:`remote_base::TotoData`
   is passed to the automation for use in lambdas.
+- **on_lidl_auriol** (*Optional*, :ref:`Automation <automation>`): An automation to perform when a
+  Lidl Auriol weather station data has been decoded. A variable ``x`` of type :apistruct:`remote_base::LidlAuriolData`
+  is passed to the automation for use in lambdas. Create template sensors to pass them further to HA. The sensor repeats the 52-bit code seven times, it is a good idea to add a throttle filter. The sync word starts with low and is only 4ms, set remote_receiver idle time smaller than that, like 3ms.
 
 .. code-block:: yaml
 
@@ -498,6 +502,14 @@ Remote code selection (exactly one of these has to be included):
   - **rc_code_1** (*Optional*, int): The first 4-bit Toto code (usually a command parameter) to trigger on. Range is 0 to 0xF.
   - **rc_code_2** (*Optional*, int): The second 4-bit Toto code (usually a command parameter) to trigger on. Range is 0 to 0xF.
 
+- **lidl_auriol**: Trigger on a decoded Lidl Auriol weather station data.
+
+  - **id** (**Required**, int): 8-bit identifier, unique to the sensor.
+  - **battery_level** (*Required*, bool): false when the battery is low.
+  - **channel** (*Required*, int): RF channel.
+  - **temperature** (*Required*, int): Measured temperature.
+  - **rain** (*Required*, int): Measured rain delta (impulses).
+
 .. note::
 
     The **CanalSat** and **CanalSatLD** protocols use a higher carrier frequency (56khz) and are very similar.

components/remote_transmitter.rst

@@ -953,6 +953,30 @@ Configuration variables:
 - All other options from :ref:`remote_transmitter-transmit_action`.
    - **Note**: Toto remotes repeat all codes three times at a 32ms interval. This behavior will occur by default, but may be overridden by specifying ``repeat`` and ``wait time`` configuration variables. 
 
+.. _remote_transmitter-transmit_lidl_auriol:
+
+``remote_transmitter.transmit_lidl_auriol`` **Action**
+
+This :ref:`action <config-action>` sends a Lidl Auriol weather station data to a remote transmitter and to the receiver station.
+
+.. code-block:: yaml
+
+    on_...:
+      - remote_transmitter.transmit_lidl_auriol:
+          id: 240
+          battery_level: true
+          channel: 0
+          temperature: 21
+          rain: 10
+          # Repeats 7 times
+
+Configuration variables:
+
+- **id** (**Required**, int): 8-bit identifier, unique to the sensor.
+- **battery_level** (*Required*, boolean): false when the battery is low.
+- **channel** (*Required*, int): RF channel (no effect).
+- **temperature** (*Required*, float): Measured temperature.
+- **rain** (*Required*, int): Measured rain delta (impulses).
 
 .. _remote_transmitter-rc_switch-protocol: