140ElementsModell SEGMENTATION FAULT

[SaschaGolod]

When i try to run the 140ElementsModell with the UMAT-140Elements.for file i am getting:

*** ABAQUS/standard rank 0 encountered a SEGMENTATION FAULT

*** ERROR CATEGORY: ELEMENT LOOP

all the UMAT files and source files in 1 file. Abaqus 2022 is running, but calculates only Step 1 Inc 1, Step 2 Inc 1, then error accures.

The Properties.txt file is the in correct directory, The CycleJump Log_File was created, but is blank.

[YOMI079]

When i try to run the 140ElementsModell with the UMAT-140Elements.for file i am getting:

*** ABAQUS/standard rank 0 encountered a SEGMENTATION FAULT

*** ERROR CATEGORY: ELEMENT LOOP

all the UMAT files and source files in 1 file. Abaqus 2022 is running, but calculates only Step 1 Inc 1, Step 2 Inc 1, then error accures.

The Properties.txt file is the in correct directory, The CycleJump Log_File was created, but is blank.

Has this issue been resolved?

[PD1710]

@faisal-bhuiyan sir

what changes i need to make in umat file to check it for single element...please reply

[PD1710]

I want implement this code and i'm just got stucked please help

[SaschaGolod]

i was not able to fix it. I just got to the point that i changed the directory of props.txt and the logging file and then it started running.i tested o abq614 and after a few increments it shows the errr

aborted with system error code 1073741819.
Please check the .dat, .msg, and .sta files for error messages if the files
exist.  If there are no error messages and you cannot resolve the problem,
please run the command "abaqus job=support information=support" to report and
save your system information.  Use the same command to run Abaqus that you
used when the problem occurred.  Please contact your local Abaqus support
office and send them the input file, the file support.log which you just
created, the executable name, and the error code.
Abaqus/Analysis exited with errors