cwl values not read cyclically

[Brosius18]

Hello, I have the problem that the values are not being read cyclically. This is my config:

EBUSD_OPTS="--scanconfig=full -c /home/iobroker/encon --port=8888 --httpport=8889 -d enh:/dev/serial/by-id/usb-Silicon_Labs_CP2102N_USB_to_UART_Bridge_Controller_8a07816c42deea118877d3149a583cc7-if00-port0"

ebusctl info says:

version: ebusd 25.1.25.1
update check: OK
device: /dev/serial/by-id/usb-Silicon_Labs_CP2102N_USB_to_UART_Bridge_Controller_8a07816c42deea118877d3149a583cc7-if00-port0, serial speed, enhanced
signal: acquired
symbol rate: 22
max symbol rate: 73
min arbitration micros: 2
max arbitration micros: 34
min symbol latency: 10
max symbol latency: 15
scan: finished
reconnects: 0
masters: 2
messages: 141
conditional: 0
poll: 0
update: 0
address 31: master #8, ebusd
address 36: slave #8, ebusd, scanning
address 37: master #18
address 3c: slave #18, scanned "MF=ENCON;ID=  ;SW=-;HW=-"

ebusd find gives only:

ebusctl find
Excellent300 Abluftmenge = no data stored
Excellent300 Ablufttemperatur = no data stored
Excellent300 AdresseModbusSlave = no data stored

But when I run:
ebusctl read Aussenlufttemperatur

The value appears in ebusctl find.

What do I need to adjust so that all values are permanently read?
The CSV is from here: https://github.com/dstrigl/ebusd-config-brink-renovent-excellent-300