Smart Lamp

A surface touch lamp with digital clock and alarm

Display

Display current time to 4-digit seven segment display with either 24-hour or 12-hour (Military or Meridiem) format

Lamp

• Touch the touch sensor (stainless steel) to activate lamp on specific brightness
• Touch again the touch sensor (stainless steel) to activate lamp on full brightness
• Touch again the touch sensor (stainless steel) to deactivate the lamp

Alarm

• Press once Set Button (Red Button) to set the alarm and the minute will blink.

  The blink indicate that you are about to adjust that number

Once in Set Alarm mode:

• Press Adjust Button (Yellow Button) to increase minute.

• Press Set Button (Red Button) again to move the cursor to the hour.

• Press Adjust Button (Yellow Button) to increase hour.

• If satisfied with the alarm, press the Set Button (Red Button) again to finalize the alarm

  Note: The time in Set Alarm Mode is formatted with 24-hour (Military) format to know if the alarm is set to AM or PM

Alarm⏰🔔

• Touch the touch sensor (stainess steel) to deactivate the alarm

  Note: The light lamp will remain it current state and will not change. Just turning off the alarm.

Time

• Long press the Set Button (Red Button) to set the current time. The minute will blink

  The blink indicate that you are about to adjust that number

• Press Adjust Button (Yellow Button) to increase minute.
• Press Set Button (Red Button) again to move the cursor to the hour.
• Press Adjust Button (Yellow Button) to increase hour.
• If satisfied with the time, press the Set Button (Red Button) again to finalize the time