One Channel Vibration Plus Unable to Config Measurement Mode

[stokes776]

For the One Channel Vibration Plus sensor, I check the box for Auto Config, then check the box on 'Measurement Mode' and try to change it to the second value in the dropdown.

When I click Done, and then go back into the same node, my changes done above are not saved/persisted:

Are we not able to modify this setting yet perhaps?

[stokes776]

If I check every optin in the 'Auto Config' section, click Done, and then re-enter the node, most of the options remained checked, but I noticed a few others that return to unchecked: